Dynamic Engineering PMC2PCI Dokumentacja Pobierz pdf (Strona 96)

PC BIOS

10-2 PP 41x/03x

Operator communication with the PC BIOS is usually through a serial terminal connected to the

COM1 or COM2 serial ports. This can be reconfigured with a board option switch to use a VGA

display (either using the on-board graphics interface, if fitted, or via a PMC module) and a separate

keyboard. Section 6.1.1 describes the location and settings for this switch. Selection between

COM1 and COM2 is done via a board option switch. Section 6.1.2 describes the location and

settings for this switch.

A VT100-compatible serial terminal or emulator program should be used. By default the serial line

is programmed to operate at 9600 Baud with 8 data bits, 1 stop bit and no parity (9600-8N1).

There is no flow control. For fast terminals, the baud rate can be increased via the Serial

Console Baud Rate field of the Main Setup menu.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 127 128

Brak uwag

Dynamic Engineering PMC2PCI Dokumentacja Strona 96