Dynamic Engineering PMC2PCI Dokumentacja Pobierz pdf (Strona 31)

HARDWARE INSTALLATION

PP 41x/03x 2-9

2.7.1 Hard Disk Storage Kit (AD CP1/DR1)

The option kit comprises:

• A 2.5 inch EIDE disk drive

• A ribbon cable assembly

• Four M3 x 10mm screws

• Four M3 x 5mm spacers

The ribbon cable assembly has a 50-way connector at one end and a 44-way connector at the

other end. The 50-way connector plugs into the disk drive and the 44-way plugs into P5 on the

PP 41x/03x.

1) Plug the 50-way connector into the disk drive as shown in Figure 2-7 below, note the

orientation.

50-way Connector

44-way Connector

Pin 1

Stripe

Figure 2-7 Disk Drive Cable Installation

2) Plug the 44-way connector into P5, note the orientation.

3) Fix the disk drive into position using the four screws and spacers provided. Do not over

tighten the screws.

NOTE: If the board is likely to be subjected to mechanical vibration a suitable thread lock

compound applied to the screws should be considered.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 127 128

Brak uwag

Dynamic Engineering PMC2PCI Dokumentacja Strona 31